top of page

Measurement arms are usually the easy way present a probe for tool measurement.

Wherever possible, he probe is kept outside the machining area when not in use. This allows the stylus to be kept clean and avoid accidental damage during part load/unload.

Units with more than one probe are sometimes require for measurement of right angle heads.

All measurement routines are provided at time of installation.

Programmer and operator training is performed after completion of the installation of the unit.

Our units are usually mounted inside the wall of the machine and swing out into the machining area.

In special circumstances, units can also be mounted inside the tool change area if no other suitable position can be found.

​
 

bottom of page